Dewalt table saw parts dwe74808/7/2023 A hammer is the last tool you want to use here. The armature must be pressed in exactly square and this would be difficult to do by hand. With a digital caliper I measured the bearing and the bore for the armature and found that they had no clearance whatsoever. Found that from inside I could use a screwdriver to gently pry the armature out of the gear case. Removed 3 screws holding arbor plate to gear case, then carefully, a bit at a time, pried the arbor plate off, never prying on the ears that the screws go through as they could easily be broken off. Once I had the motor cover and gear case removed I found that the armature and arbor were press fit parts and waited until I had new parts in hand to determine best was to disassemble. Found the exact part at, with recommendations for other useful parts. Turned crank to raise blade and found aluminum shavings coming out of threaded portion of gear case. Unplug saw, removed blade, turned saw upside down and vacuumed dust off.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |